Kingston HyperX Predator 16GB DDR3-1866 Quad kit

DESCRIPTION

Kingston's KHX16C9T2K4/32X is a kit of four 1G x 64-bit (8GB)DDR3-1600 CL9 SDRAM (Synchronous DRAM) 2Rx8 memorymodules, based on sixteen 512M x 8-bit DDR3 FBGA components per module.

Each module kit supports Intel® XMP(Extreme Memory Profiles). Total kit capacity is 32GB.

Eachmodule kit has been tested to run at DDR3-1600 at a lowlatency timing of 9-9-9 at 1.5V.

The SPDs are programmed toJEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.

Each 240-pin DIMM uses gold contact fingers and requires+1.5V.

The JEDEC standard electrical and mechanical specifications are as follows:

XMP TIMING PARAMETERS

• JEDEC: DDR3-1333 CL9-9-9 @1.5V

• XMP Profile #1: D3-1600 CL9-9-9 @1.5V

SPECIFICATIONS

CL(IDD) 9 cycles

Row Cycle Time (tRCmin) 49.5ns (min.)

Refresh to Active/Refresh 260ns (min.)Command Time (tRFCmin)

Row Active Time (tRASmin) 36ns (min.)

Maximum Operating Power 2.460 W*

UL Rating 94 V - 0

Operating Temperature 0o C to 85o C

Storage Temperature -55o C to +100o C

*Power will vary depending on the SDRAM used.

FEATURES

• JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 667MHz fCK for 1333Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 9, 8, 7, 6

• Posted CAS

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)

• 8-bit pre-fetch• Burst Length: 8 (Interleave without any limit, sequential withstarting address “000” only), 4 with tCCD = 4 which does notallow seamless read or write [either on the fly using A12 orMRS]

• Bi-directional Differential Data Strobe

• Internal(self) calibration : Internal self calibration through ZQpin (RZQ : 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C,3.9us at 85°C < TCASE < 95°C

• Asynchronous Reset

• PCB : Height 2.122” (53.90mm) w/ heatsink, double  sidedcomponent